Rules for the Cluster Ring

Here are the rules to follow to ensure that a Cluster ring is correct:

1.   The cluster ring must be on the Cluster layer. The Cluster tool can only trim lines that are on the Cluster layer.

2.   There can only be one cluster ring per figure, with no other geometry on this layer.

3.   The cluster ring can only be a Circle, Square, N-Sided Polygon or a Closed Polyline of any shape (it can also be lines, arcs and/or polylines joined to form a closed polyline).

 Important:

If your figure cannot meet all the rules mentioned previous, do not use the Cluster layer. The Cluster layer should not be used for anything other than the Cluster ring. If used improperly in a figure, it will be entirely removed during the Clustering process.